Panasonic DP-MB251CX - Page 90

Feature Code Selection
All FTP/SMB
address erase
#578 To erase all FTP destinations and SMB folder destinations stored in the unit.
R Disconnect the following cables before activating this feature.
– Telephone line cord
– USB cable
– LAN cable
M0N “NO” (default)
M1N “YES”
To erase FTP destinations:
1. MMENUN A MBNM5NM7NM8N
2. M1N A “YES” A MSETN
3. M1N A “YES” A MSETN A MMENUN
To erase SMB folder destinations:
1. MMENUN A MBNM5NM7NM8N
2. M1N A “YES” A MSETN
3. M0N A “NO” A MSETN
4. M1N A “YES” A MSETN A MMENUN
LAN mode
#580 To select LAN mode.
Important:
R To set this feature, make sure that:
– The unit is in standby mode.
– The document is not set on the automatic document feeder.
– The delayed send feature is not activated (feature #412 on page 58).
M0N “OFF”
M1N “WIRED” (default)
M2N “WIRELESS”
Wireless status
*1
#581 If feature #580 is set to “WIRELESS”, you can check the status of the wireless
LAN connection by pressing MCN or MDN.
WPS-PBC
*1
#582 To set up the wireless LAN connection using WPS-PBC. This feature is the same
feature as pressing the MWPSN button. See page 24 for details.
WPS-PIN
*1
#583 To set up the wireless LAN connection using WPS-PIN. See page 24 for details.
SSID search
*1
#584 To set up the wireless LAN connection by finding the SSID automatically on the
network. See page 24 for details.
Manual setup for
wireless
*1
#585 To set up the wireless LAN connection by entering the required information
manually. See page 24 for details.
Wireless restore
*1
#586 To restore all wireless LAN connection settings.
M0N “NO” (default)
M1N “YES”
1. MMENUN A MBNM5NM8NM6N
2. M1N A “YES” A MSETN
3. M1N A “YES” A MSETN
*1 These features are available only when feature #580 is set to “WIRELESS”.
90
12. Programmable Features