EYFR03 User Manual 84 of 110 v1.6.0
Chapter 7: EtherNet/IPTM 20 January 2020
172
Instance number of items to run. Deactivate any running parameter,
job, or group if 0.
Type of item to run:
0 - Parameter
1 – Group
2 – Job
Ignored if Item Number is 0.
When this value changes, the batch counts of the currently running
parameter or group is reset.
When set, suspends the unit without stopping a running parameter,
group, or job.
Sets the batch size for the selected parameter. If Item Type is not 0
(Parameter), this value is ignored. If this value is 0, the parameter size
stored in the EYFR03 will be used.
Total size: 106 bytes
181
Instance number of items to run. Deactivate any running parameter,
job, or group if 0.
Type of item to run:
0 - Parameter
1 – Group
2 – Job
Ignored if Item Number is 0.
A temporary batch size to use for each tool or 0 to make no
modification.
16-bit word with each bit used to reset the batch of a tool when set (bit
0 resets tool 1, bit 1 resets tool 2, etc.)
16-bit word with each bit used to suspend a tool (bit 0 set suspends tool
1, bit 1 set suspends tool 2, etc.)
When set, suspends the unit without stopping a running parameter,
group, or job.
Total size: 24 bytes
Note that the values in this point refer to tools, but the EYFR03 runs parameters. This means
that you must select a parameter, group, or job using the tools you want to control with this
connection point. If a tool is not active in the selected parameter, group, or job, attempts to
control them will be ignored.
Input (T->O) Connection Points
This section defines the connection points are used by EYFR03 to send output data to the
network. The connection points are in the range 100-129 and are grouped by their content.
• 10x: Connection points provided for backwards compatibility with the EYFR01. (Detailed in
the Input Connection Points for Backwards Compatibility section later in this chapter)
• 11x: Last tightening data
• 12x: Current qualifier status
To Next Page
