Control Panel and LED Indicators
A Skip button (SKIP)
If you press this button after a double feed or a dog-eared document is detected and scanning has
been paused, the document that was detected as a double feed or the dog-eared document will be
scanned, and then ejected from the scanner. Scanning will continue after the document is scanned
and ejected.
B LED (Green)
Shows the scanner’s status.
C Power button ( )
Press the power button for more than one second to turn the unit off.
D LCD (KV-S5076H only)
If you are using a KV-S5076H with Image Capture Plus, you can perform push scan using the LCD.
Registered jobs are displayed on the LCD. Use the cursor button and OK button to select a job.
Also, error codes and messages corresponding to the scanner status are displayed on the LCD.
E Cursor button (KV-S5076H only)
F OK button (OK) (KV-S5076H only)
G Start/Stop button (START/STOP)
• If you set [Wait Key] for "Manual Feed Mode"
*1
in your application software, pushing this button
starts scanning.
• During scanning, pushing this button stops scanning.
• If you press this button after a double feed or a dog-eared document is detected and scanning
has been paused, the document that was detected as a double feed or the dog-eared document
will be ejected from the scanner without being scanned. Scanning will stop.
H LED (Red)
Lights when an error occurs.
*1
For details about "Manual Feed Mode", refer to the Image Capture Plus, TWAIN, or ISIS help.
Operating Manual 13
Location of Controls
To Next Page
Loading...
