About LED
The status of the scanner is displayed by the LED (Green) (C) and the LED (Red) (D), as shown in the
table below:
C LED (Green) D LED (Red) Status
OFF OFF Power OFF
*1
ON OFF Ready mode or Scanning
Blinking (Slow) OFF Sleep mode
*2
OFF ON Error
*3
Blinking (Fast) OFF Warming up
Blinking (Fast, 2 times consecutively)
OFF Double Feed Skip mode
Blinking (Fast, 3 times consecutively) OFF Dog-ear Detection Skip mode
*1
If the power off feature in sleep mode is enabled, and if no operation is performed for a certain period of time, the scanner will be
turned off automatically. Press the power button of the scanner to turn it on. You can enable/disable the power off feature, and change
the time until the scanner turns off in User Utility.
*2
If no operation is performed for 15 minutes or longer, the scanner will enter sleep mode automatically to conserve energy. Press the
Start/Stop button of the scanner to return to ready mode. The time until the scanner enters sleep mode can be changed in User
Utility.
*3
For details about the error, refer to "Error Messages (KV-S5076H only)" (page 77) or check in User Utility.
14 Operating Manual
Location of Controls
To Next Page
Loading...
