4. Place the documents on the feed tray (A) with the scanning side facing up.
• Align the document position so that the center of the smallest sheet will be fed to the center of the paper
feed roller (B). If the document is not properly aligned, the pages will not be fed correctly.
Notice
• The height of the documents should not exceed the limit mark (C) on the document guide.
Exceeding the limit mark may cause a paper jam or skewing.
• Depending on the types of paper, the document may not be fed smoothly. In such case, reduce
the number of sheets of the document.
34 Operating Manual
Operation
To Next Page
Loading...
