Component Identification
10
■ Operation Panel
Power button
Press the power button for more than one second to turn the unit off.
LED (Red)
Lights when an error occurs.
LED (Green)
Shows the scanner’s status.
7-segment LED
If you are using the scanner with Image Capture Plus, you can perform a push scan using the 7-segment LED.
A registered job number is displayed on the 7-segment LED. Use the cursor button ( ) to select a job.
Cursor button
Skip button
If you press this button after a double feed or a dog-eared document is detected and scanning has been paused,
the document (or documents) detected as a double feed or the dog-eared document will be scanned, and then
ejected from the scanner. Scanning will continue after the document is scanned and ejected.
Start/Stop button
•
During scanning, pushing this button stops scanning.
• If you press this button after a double feed or a dog-eared document is detected and scanning has been
paused, the document (or documents) detected as a double feed or a dog-eared document will be ejected from
the scanner without being scanned. Scanning will stop.
• If you set [Wait Key] for "Manual Feed Mode" in your application software, pushing this button starts scanning.
For details about "Manual Feed Mode", refer to the Image Capture Plus, TWAIN, or ISIS help.
1 2 3 54 6
7
1
2
3
4
5
6
7
To Next Page
Loading...
