Panasonic KX-NCP1000 - Page 272

Programming Manual References
None
Feature Guide References
None
ISDN CO / QSIG Master / QSIG Slave—T308
Specifies the maximum time that the PBX waits for a reply after receiving the Release message from ISDN.
Value Range
0–600 ´ 100 ms
Maintenance Console Location
3.32 [1-1] Slot—Card Property - BRI type/PRI type
Programming Manual References
None
Feature Guide References
None
ISDN CO / QSIG Master / QSIG Slave—T309
Specifies the length of time that the PBX tries to disconnect the data link, before disconnecting the call.
Value Range
0–3000 ´ 100 ms
Maintenance Console Location
3.32 [1-1] Slot—Card Property - BRI type/PRI type
Programming Manual References
None
Feature Guide References
None
ISDN CO / QSIG Master / QSIG Slave—T310
Specifies the maximum time that the PBX waits for a continuance message after receiving the Incoming Call
Proceeding message.
272 PC Programming Manual
3.32 [1-1] Slot—Card Property - BRI type/PRI type