Panasonic KX-NCP1000 - Page 388

Value Range
DTMF, Pulse, MFC-R2
Maintenance Console Location
3.44 [1-1] Slot—Port Property - E1 Port
Programming Manual References
None
Feature Guide References
1.5.4.4 Dial Type Selection
1.22.1 E1 Line Service
E1 Receiver Type
Selects the type of signal the PBX receives from the E1 line.
This should be set to MFC-R2 when receiving ANI (Automatic Number Identification) numbers from the E1
line.
Value Range
DTMF, Pulse, MFC-R2, Undefined
Maintenance Console Location
3.44 [1-1] Slot—Port Property - E1 Port
Programming Manual References
None
Feature Guide References
1.22.1 E1 Line Service
Receive Digits
Specifies the maximum number of digits to be received from a DDI/DID number when receiving a call with the
DDI/DID number.
Value Range
0–15
Maintenance Console Location
3.44 [1-1] Slot—Port Property - E1 Port
388 PC Programming Manual
3.44 [1-1] Slot—Port Property - E1 Port