Panasonic KX-NCP1000 - Page 408

Maintenance Console Location
3.47 [1-1] Slot—Port Property - EM Port (KX-TDE series only)
Programming Manual References
None
Feature Guide References
None
CO Pulse Speed
Selects the speed at which pulse dials are sent to the E
& M line.
Value Range
10 pulse/s, 20 pulse/s
Maintenance Console Location
3.47 [1-1] Slot—Port Property - EM Port (KX-TDE series only)
Programming Manual References
None
Feature Guide References
1.5.4.4 Dial Type Selection
Wink Signal Time-Out
Specifies
the length of time that the PBX waits to receive a wink signal after seizing a trunk. If a wink signal is
not received before this timer expires, the trunk is released.
Value Range
64 ´ n (n=1–128) ms
Maintenance Console Location
3.47 [1-1] Slot—Port Property - EM Port (KX-TDE series only)
Programming Manual References
None
Feature Guide References
None
408 PC Programming Manual
3.47 [1-1] Slot—Port Property - EM Port (KX-TDE series only)