Panasonic KX-NS1000 - Page 175

Hold
Hold
(to be Retrieved from
Another Extension)
*1
Transfer to Trunk
Transfer to
Extension
Mode 2
(Default)
Flashing the
hookswitch
+
Hold Feature No.
+
Going on-hook
Flashing the hookswitch
+
Hold Feature No.
+
Going on-hook
Flashing the
hookswitch
+
Trunk Access No.
Flashing the
hookswitch
+
Extension No.
Mode 3
Flashing the
hookswitch
+
Hold Feature No.
+
Going on-hook
Flashing the hookswitch
+
Hold Feature No.
+
Hold Feature No.
+
Going on-hook
Flashing the
hookswitch
+
Hold Feature No.
+
Trunk Access No.
Flashing the
hookswitch
+
Extension No.
Mode 4
Flashing the
hookswitch
+
Hold Feature No.
+
Going on-hook
Flashing the hookswitch
+
Hold Feature No.
+
Hold Feature No.
+
Going on-hook
Flashing the
hookswitch
+
Hold Feature No.
+
Trunk Access No.
Flashing the
hookswitch
+
Hold Feature No.
+
Extension No.
*1
These operations must be performed when the held call is intended to be retrieved from another extension using the holding
extension number.
If the following occurs frequently with an SLT, choose "
Mode 2", "Mode 3", or "Mode 4":
a. When an SLT user receives a call, reorder tone is heard or nobody answers the call.
b. When an SLT user goes off-hook, reorder tone is heard instead of a dial tone.
If a call is not terminated after going on-hook, the above cases occur. To avoid these problems, choose
"Mode 2", "Mode 3", or "Mode 4". Every call will be terminated unless the Hold feature number is entered
after flashing the hookswitch in Mode 2, Mode 3, and Mode 4.
• Hold Alarm tone pattern has a default. (® 6.2.1 Tones/Ring Tones).
PC Programming Manual References
10.3 PBX Configuration—[2-3] System—Timers & Counters—Dial / IRNA / Recall / Tone
→
Recall—Hold Recall
→ Recall—Disconnect after Recall
10.6.1 PBX Configuration—[2-6-1] System—Numbering Plan—Main—Features
→ Call Hold / Call Hold Retrieve
→ Call Hold Retrieve : Specified with a Holding Extension Number
→ Hold Retrieve : Specified with a Held CO Line Number
10.9 PBX Configuration—[2-9] System—System Options
→Option 1— PT Operation—Automatic Hold by ICM / CO / ICD Group Key
→Option 1— PT Operation—Hold key mode
→Option 5— SLT—SLT Hold Mode
User Manual References
1.4.2 Holding a Call
Feature Guide 175
2.13.1 Call Hold