Panasonic KX-NS1000 - 2.21.2 Flexible Buttons

This PBX supports 4 modification tables, each of which can be used for any number of trunk groups. Each
table has
10 locations for local/international calls and one for long distance calls. The PBX checks the local/
international call data first. If a match is not found, the long distance call data is applied.
After the caller’s number is modified by the Length of Digits modification tables or CLIP modification tables,
the PBX checks the leading digits of the modified number for an area code programmed in the Caller ID
modification table assigned to that trunk group. For more information, refer to 11.1.3 PBX
Configuration—[3-1-3] Group—Trunk Group—Caller ID Modification—Leading Digits in PC Programming
Manual.
[Example]
012
Local/International
Call Data 1
Local/International
Call Data 2
:
Local/International
Call Data 10
Long Distance
Call Data
Area Code Removed No. of Digits
Added No.
Trunk
Group No.
1
2
:
Modification
Table
1
3
:
Modification Table 1
00
:
Not
programmable
3
2
0
:
001
:
Blank
0
<Table Selection>
<Modification Table>
Note
When caller’s information is sent through an ISDN line and the call type is Subscriber, National, or
International, the following modification table is used instead of the above table:
Subscriber Call Data
National Call Data
International Call Data
Removed No. of Digits
Added No.
<Modification Table>
0
0
0
Blank
0
00
212 Feature Guide
2.19.1 Caller ID