Location (System Speed
Dialling No.)
Telephone No.
*1
System Speed Dialling
Name
*2
CLI Destination
*3
: : : :
*1
® 14.1 PBX Configuration—[6-1] Feature—System Speed Dial— CO Line Access Number + Telephone Number
*2
® 14.1 PBX Configuration—[6-1] Feature—System Speed Dial—
Name
*3
® 14.1 PBX Configuration—[6-1] Feature—System Speed Dial— CLI Destination
Caller’s Name Reference
A name
can also be shown on the display or SMDR. The PBX searches for the name in the following order:
1. Personal Speed Dialling data of the original called extension
2. System Speed Dialling (Caller ID) Table
3. Caller ID name received from the public line (Caller ID Name Reference)
If the name is not found, it will not be displayed.
Conditions
[General]
• Caller ID signalling type can be selected through system programming.
• The Caller ID Name Reference is only available for calls from the public network.
[Caller ID to SLT Port]
• Hardware Requirement:
An LCOT2+SLC2, BRI4+SLC2, PRI30+SLC2, or PRI23+SLC2 card
For details about the hardware requirements for a legacy gateway (® 5.3.1 Stacking Connection), refer
to the documentation of the legacy gateway.
• This feature complies with ETSI (European Telecommunications Standards Institute)-type FSK and
Bellcore-type FSK.
• When the caller’s number is sent to an SLT, a Trunk Access number can be automatically added to the
telephone number through system programming for calling back.
• When the caller’s number exceeds 16 digits, the SLT receives only the first 16 digits, not counting the
preceding Trunk Access number (if it is programmed to be added).
• If a call is transferred to an SLT, the transferring extension’s information will be shown on the SLT. If the
transferring extension goes on-hook before the call is answered, the original caller’s information will be
shown.
• When the Caller ID has information, such as private, out of area, or long distance, the information will be
shown instead of the caller’s number and name.
• Even if the caller’s name is sent, the name may not be shown depending on the type of SLT.
• Incoming Call Log information is not shown on the SLT.
• Caller ID shows whether the call is an intercom or trunk call by default. This setting can be disabled through
system programming.
• A caller ID name received from the network via a PRI23 card will not be displayed on an SLT. However, if
the received caller ID matches a System Speed Dialling entry, and a name is registered for that entry, it
will be displayed.
PC Programming Manual References
10.3 PBX Configuration—[2-3] System—Timers & Counters—Miscellaneous
→
Caller ID—Waiting to receive
→ Caller ID—Visual Caller ID Display
10.9
PBX Configuration—[2-9] System—System Options—Option 4—
Private Network—Public Call
through
Private Network—Minimum Public Caller ID Digits
214 Feature Guide
2.19.1 Caller ID
To Next Page
Loading...
