Even if the Inter-digit time
does not expire, the PBX stops receiving the DID/DDI number when the received
number is found in the DID/DDI table. The PBX then routes the call to the corresponding destination. If the
received number matches several entries in the table, the call is directed to the destination of the first
matching entry.
[Example]
If a call is received in Lunch mode;
Received Number Destination Explanation
123-4567 Extn. 100 The PBX finds the match in location 0001 in the table
after receiving "7". So the call is routed to extension
100.
123-456 Extn. 101 The Inter-digit time
expired after receiving "6". The PBX
finds the match in location 0003 in the table. So the call
is routed to extension 101.
PC Programming Manual References
10.3 PBX Configuration—[2-3] System—Timers & Counters—Miscellaneous
—
Incoming Call Inter-digit
Timer—DDI / DID
18.2 PBX Configuration—[10-2] CO & Incoming Call—DIL Table & Port Settings—DDI / DID / TIE / MSN
→ Distribution Method
→ DDI/DID/TIE/MSN—Remove Digit
→ DDI/DID/TIE/MSN—Additional Dial
18.3 PBX Configuration—[10-3] CO & Incoming Call—DDI / DID Table
Feature Guide References
2.1.1.5 Calling Line Identification (CLI) Distribution
3.2.1.40 Service Group
5.1.3 Tenant Service
5.1.4 Time Service
6.1 Capacity of System Resources
28 Feature Guide
2.1.1 Incoming Trunk Call Features
To Next Page
Loading...
