Location No. Name
CLI Destination
Day Lunch ... Day Lunch ...
01
123-
4567
A
Company
Enable Disable ... 101 100 ...
02
123-
2468
C
Company
Enable Disable ... 102 100 ...
: : : : : : : : :
10 : : : : : : : :
Note
The following settings can also be specified in the MSN table:
• Tenant number: determines the time mode
(day/lunch/break/night) for the corresponding trunk.
• UM service group number: determines the service group to use when a call is handled by the Unified
Messaging system.
• VM trunk group number: used in Voice Mail DPT
(Digital) Integration with a VPS.
Explanation:
If the MSN "123-4567" is received from BRI port 1:
1. Checks the number in the table.
® Matches the number in location 01.
2. Checks the time mode.
In Day mode: CLI is enabled. Route to CLI destination.
In Lunch mode: CLI is disabled. Route to MSN destination, extension 100.
Conditions
• To use this feature, the MSN service must be assigned as the distribution method for a trunk port.
• MSN Modification
It is possible to modify a received MSN to make it shorter, which may be convenient when programming
the MSN table. The modification method
(removed number of digits/added number) can be programmed
on a trunk port basis.
[Modification Example]
• When using point-to-multipoint configuration with a BRI, do not connect another ISDN terminal device in
parallel
with the PBX. As only two channels can be used at one time with the BRI, the other ISDN terminal
device may monopolise both channels.
PC Programming Manual References
18.2 PBX Configuration—[10-2] CO & Incoming Call—DIL Table & Port Settings—DDI / DID / TIE / MSN
→
Distribution Method
→ DDI/DID/TIE/MSN—Remove Digit
30 Feature Guide
2.1.1 Incoming Trunk Call Features
To Next Page
Loading...
