Feature Time Source
Periodic maintenance Local PBX
LPR Time Local PBX
PT idle time display Local PBX
PT Time format (12H/24H) Master Unit
PS idle time display Local PBX
PS note alarm Local PBX
Activation key expiration Master Unit
Error log Local PBX
SNMP, syslog Local PBX
File time stamp Local PBX
CTI applications (first and third party) Uses computer’s time
Time sent to UM Local PBX
UM time reading Uses UM’s time
*1
14.6 PBX Configuration—[6-6] Feature—Tenant— Time Service Mode
Conditions
• KX-NSN001 (Activation Key for One-look Network) is required for each PBX in the network to use this
feature.
• A maximum of 15 Slave units can be registered to the Master unit.
• Tenants (® 5.1.3 Tenant Service) and ICD groups
(® 2.2.2 Incoming Call Distribution Group Features)
can contain extensions from multiple sites, and therefore multiple time zones. For time-sensitive
operations, such as Time Service (® 5.1.4 Time Service), system programming determines which PBX’s
clock is used for determining the current time.
® 14.6 PBX Configuration—[6-6] Feature—Tenant—
Time Service Mode
• Due to hardware constraints, the following resources are not shared between sites:
– Echo canceller
– OGM
– BGM
– VoIP resources
– PS handover
– Network time synchronisation signal
• The Master unit must be running for the One-look network to operate.
• It
is
recommended that One-look networks be located in one country/area. Operation cannot be guaranteed
for One-look networks that span multiple countries/areas.
Installation Manual References
2.1.1 System Configurations
8.4.1 One-look Network
Feature Guide 359
4.2.1 One-look Networking Overview
To Next Page
Loading...
