[SIP Trunk]
• The necessary
account information for connecting the SIP trunk must be configured at the Backup Master
unit beforehand. This information is not automatically set from the Master unit.
• This feature can be used only between the Master unit and the Backup Master unit. If a SIP trunk is specified
as a backup at a site other than the Backup Master unit (including the Master unit), the setting is ignored.
Installation Manual References
2.1.1 System Configurations—One-look Networking Survivability
8.4.2 One-look Networking Survivability
→Backup Master Mode
→Isolated Mode
PC Programming Manual References
3.1 Home Screen
9.5.1 PBX Configuration—[1-1] Configuration—Slot—Site Property—Main—Main—
Isolated Mode
9.11 PBX Configuration—[1-1] Configuration
—Slot—V-SIPGW—Port Property—Main—
Backup
Feature Guide 367
4.2.3 One-look Networking Survivability
To Next Page
Loading...
