• The Call Log button light shows the current status as follows:
Off: No incoming call. Or you have already viewed the call log.
Red on: You have missed calls to view.
• If your call is answered by another extension, the caller
’s information is recorded on the
displays of both your extension and the answering extension.
• You can lock your call log display by using an extension PIN (Personal Identification Number),
so that you can prohibit access to your logged information (Display Lock). Refer to
"3.1.2 Settings on the Programming Mode".
• You can also have a Call Log button for an ICD Group (Incoming Call Distribution Group).
• If a call arrives while you are using the call log, the call log display will be replaced with the
caller’s information.
Customising Your Phone
• 3.1.3 Customising the Buttons
Create or edit a Call Log button or Call Log for ICD Group button.
Calling with the Outgoing Call Log
You can redial using the outgoing call log.
To call
• The following PSs can use outgoing call log information to other extensions (including TIE)
with same information as a PT connected to the PBX.
KX-TCA185/KX-TCA285/KX-TCA385
• PSs other than these may not display the same outgoing call log information as a PT
connected to the PBX.
• For details about referencing the outgoing call log, refer to the PS’s documentation.
To call with the REDIAL button
To Next Page
Loading...
