• If the destination of a sensor call has set FWD, the sensor call will be redirected to the FWD destination.
However, if the FWD destination is not supported as the destination of a sensor call (e.g., an outside party),
the call will be received at the original destination. (® 2.3.2 Call Forwarding (FWD))
• The following features cannot be used when a sensor call is received:
– Alternate Receiving—Voice (® 2.5.3 Intercom Call)
– Hands-free Answerback (® 2.4.4 Hands-free Answerback)
– Consultation Hold/Call Hold (® 2.13.1 Call Hold)
– Call Transfer (® 2.12.1 Call Transfer)
– Executive Busy Override (® 2.10.2 Executive Busy Override)
• Sensor call information is output on SMDR.
Installation Manual References
4.7.1 DOORPHONE Card (KX-NS0161)
4.9 Connecting to a Doorphone, Door Opener, and/or External Sensor
PC Programming Manual References
9.30 PBX Configuration—[1-1] Configuration—Slot—DOORPHONE Card—Card Property
→
For Sensor - Input Signal Decision Time
→ For Sensor - Input Signal Detection Reopening Time
10.3 PBX Configuration—[2-3] System—Timers & Counters—Miscellaneous— External Sensor—Ring
Duration
10.8.3 PBX Configuration—[2-8-3] System—Ring Tone Patterns—Call from Others— External
Sensor—Ring Tone Pattern Plan 1–8
13.5 PBX Configuration—[5-5] Optional Device—External Sensor
196 Feature Guide
2.18.3 External Sensor
To Next Page
Loading...
