Panasonic KX-NS1000 - Call Distribution Port Group

4.3.2.3 Call Distribution Port Group
Description
It is possible to set which virtual port receives each call depending on the telephone number of the called party.
By assigning each port to a Call Distribution Port Group (CDPG), it is possible to select which group receives
each call. CDPG settings cover all V-IPGW cards in the PBX, which allows for ports on different cards to be
assigned to the same CDPG. In other words, two 8-port cards can be used as one 16-port card.
Programming Example:
To enable this feature, it is necessary to programme the following 2 tables through system programming:
• CDPG Table
- in order to assign ports to Call Distribution Port Groups.
• Hunt Pattern Table
- in order to programme a priority list of CDPG destinations for each leading number.
[Programming Example of the CDPG Table]
V-IPGW Card Number
Port Number Call Distribution Port Group
*1
1 1 CDPG 1
1 2 CDPG 2
1 : :
1 8 CDPG 2
2 1 CDPG 1
2 : :
2 8 CDPG 3
*1
® 9.13 PBX Configuration—[1-1] Configuration—Slot—V-IPGW16—Port Property— Call Distribution Port Group
[Programming Example of the Hunt Pattern Table]
No.
Leading
Number
*1
Call Distribution Port
Group (1st)
*2
Call Distribution Port
Group (2nd)
*2
…
Call Distribution Port
Group (16th)
*2
1 10 CDPG 1 CDPG 4 … -
2 20 CDPG 1 CDPG 2 … CDPG 3
: : : : … :
32 300 CDPG 8 CDPG 11 … -
*1
® 9.12.2 PBX Configuration—[1-1] Configuration—Slot—Shelf Property - Virtual IP Gateway—Hunt Pattern—Hunt Pattern 1–
16— Leading Number
*2
® 9.12.2 PBX Configuration—[1-1] Configuration—Slot—Shelf Property - Virtual IP Gateway—Hunt Pattern—Hunt Pattern 1–
16—
Call Distribution Port Group—1st–16th
Note
The same CDPG can be set for several leading numbers.
388 Feature Guide
4.3.2 Voice over Internet Protocol (VoIP) Network