2.1.1.7 Intercept Routing—No Destination
Description
Provides automatic redirection of incoming trunk calls that do not have a destination assigned. The intercept
destination is an operator (tenant/PBX).
Conditions
• Intercept Routing—No Destination on/off
The Intercept Routing—No Destination feature can be enabled or disabled through system programming.
If disabled, a reorder tone will be sent to the caller. However, the Intercept Routing—No Destination feature
always functions for calls through the ELCOT/LCOT, or T1 (LCOT/GCOT) card even when disabled.
• If an operator (tenant/PBX) is not assigned:
The extension that is connected to the lowest-numbered port and is ready to receive calls will be the
intercept destination.
• Intercept Routing—No Destination also applies to calls from doorphones.
PC Programming Manual References
10.2 PBX Configuration—[2-2] System—Operator & BGM— PBX Operator—Day, Lunch, Break, Night
18.5 PBX Configuration—[10-5] CO & Incoming Call—Miscellaneous— Intercept—Routing to Operator -
No Destination (Destination is not programmed.)
Feature Guide References
5.1.5 Operator Features
Feature Guide 39
2.1.1 Incoming Trunk Call Features
To Next Page
Loading...
