However, in some negative wireless network conditions, Out of Range status may not be released
automatically. In this case, the PS user can manually release Out of Range status by pressing the TALK
button and confirming that a dial tone can be heard from the PBX.
• If the status of a PS is set to Out of Range at all PBXs that it is registered to, the call will be redirected to
the overflow destination of the ICD Group.
• Handover from one PBX to another PBX during a conversation is not possible.
PC Programming Manual References
10.3 PBX Configuration—[2-3] System—Timers & Counters—Miscellaneous— System Wireless—PS Out
of Range Timer
10.9 PBX Configuration—[2-9] System—System Options—Option 4— System Wireless—Out of Range
Registration
12.1.1 PBX Configuration—[4-1-1] Extension—Wired Extension—Extension Settings—Option 9— Mobile
Extension
12.2.1 PBX Configuration—[4-2-1] Extension—Portable Station—Extension Settings—Option 9— Mobile
Extension
Feature Guide References
2.2.2.3 Outside Destinations in Incoming Call Distribution Group
Feature Guide 417
4.3.6 Network ICD Group
To Next Page
Loading...
