• Up to 2 SNMP managers can be assigned.
• This PBX supports SNMP Protocol Version 1.0 and SNMP Version 1.0-TRAP.
• This PBX can only receive read-only MIBs. Write MIBs are not supported.
• This PBX supports MIB II.
• For more information regarding major and minor alarms, refer to the Installation Manual.
• For a list of the MIB object groups supported by this PBX, refer to 6.4 Supported Management Information
Base (MIB) Table in the Appendix.
• Through system programming, it is possible to select whether each type of TRAP (e.g., ColdStart) is sent
to the SNMP manager or not.
Installation Manual References
7.1.6 Troubleshooting by Error Log
PC Programming Manual References
27.3.3 Network Service—[3-3] Client Feature—SNMP Agent
Feature Guide References
5.6.4 Local Alarm Information
500 Feature Guide
5.6.5 Simple Network Management Protocol (SNMP) System Monitor
To Next Page
Loading...
