Panasonic KX-NS500 - Page 179

If two PBXs in a One-look
network have the same area ID, restrictions are applied as if they were one
PBX (restriction types 1 to 4 above).
→ 9.2.2 PBX Configuration—[1-1] Configuration—Slot—System Property—Site—Main—
Area ID
for logical partition
PBX B
(Area ID: a)
IP Trunk to Legacy Trunk: Restricted
PBX A
(Area ID: a)
One-look network
connection
IP Trunk
Legacy Trunk
• When logical partitioning is applied, calls over a TIE line and a trunk
(cases 3 and 4) are restricted. Calls
from an extension over a TIE line, and calls over TIE lines acting as relays are not restricted. However,
QSIG connections using PRI adaptors are restricted.
PC Programming Manual References
7.3.5 Utility—Log—Call Control Log
9.2.2 PBX Configuration—[1-1] Configuration—Slot—System Property—Site—Main—
Area ID for logical
partition
10.7.1
PBX Configuration—[2-7-1] System—Class of Service—COS Settings—CO & SMDR—
Extension-CO
Line Call Duration Limit
10.9
PBX Configuration—[2-9] System—System Options—Option 2—
Extension - CO Call Limitation—
For
Incoming Call
10.9 PBX Configuration—[2-9] System—System Options—Option 2—
Applying logical partitioning
11.1.1 PBX Configuration—[3-1-1] Group
—Trunk Group—TRG Settings—Main
→
CO-CO Duration Time (*60s)
→ Extension-CO Duration Time (*60s)
15.5 PBX Configuration
—[7-5] TRS—Miscellaneous—
Dial Digits Limitation After Answering—Dial Digits
PT Programming Manual References
[472] Extension-to-Trunk Call Duration
[473] Trunk-to-Trunk Call Duration
[502] Trunk Call Duration Limitation
Feature Guide References
5.1.1 Class of Service (COS)
Feature Guide 179
2.11.8 Trunk Call Limitation