5.2.2.4 Panasonic SIP Phones (P-SIP)
Description
Panasonic SIP phones (P-SIP) have the following characteristics.
• P-SIP phones use the activation keys for IP-PT/P-SIP (e.g., KX-NSM201) rather than the activation keys
for SIP extensions (e.g., KX-NSM701).
• P-SIP phones offer the same features as general SIP phones.
• P-SIP phones are registered and de-registered to/from the PBX in the same way as general SIP phones.
Refer to the corresponding P-SIP manuals for the registration and deregistration procedures.
Conditions
• Requirement:
A V-SIPEXT card is required to use a P-SIP phone.
• A KX-TGP600 can be registered to up to 8 V-SIPEXT ports. In addition, one KX-TGP600 can support up
to 8 wireless handset conversations simultaneously. However, since the number of wireless handsets is
controlled by the KX-TGP600, from the PBX's perspective it appears that the number of occupied ports
does not match the number of extensions (i.e., the PBX can only see the KX-TGP600 base unit).
Depending on the registration status of the wireless handsets, up to 8 activation keys for IP-PT/P-SIP may
be required.
• P-SIP phones are counted as general SIP phones and, therefore, are included in the maximum capacity
for general SIP phones.
Installation Manual References
4.4 Virtual Cards
PC Programming Manual References
9.15 PBX Configuration—[1-1] Configuration—Slot—Card Property—V-SIPEXT
9.16 PBX Configuration—[1-1] Configuration—Slot—Port Property—V-SIPEXT
496 Feature Guide
5.2.2 SIP (Session Initiation Protocol) Extension
To Next Page
Loading...
