5.4.3 E-mail Notification of Sensor Alarm
Description
An e-mail can be sent to a specified e
-mail address when the external sensor detects an alarm. You can put
comments in the e-mail. If you put a URL for the network camera in the comments, the recipient of the
notification can monitor the video feed from the network camera by clicking URL in the comments.
Conditions
• Hardware Requirement:
An external sensor and a DPH2 card.
• To send e-mail notifications for a sensor alarm, a DPH2 card must be installed.
• A maximum 8 sensors can be connected to the PBX. An e-mail address can be set for each external sensor.
• For users to receive sensor alarm notifications, the following settings must be configured:
– Notification e-mail for sensor alarm must be enabled
13.5 PBX Configuration—[5-5] Optional Device—External Sensor
Sensor Alarm—Email
notification
– E-mail address
13.5 PBX Configuration—[5-5] Optional Device—External Sensor
Sensor Alarm—Email Address
– Comment for e-mail
13.5
PBX Configuration—[5-5] Optional Device—External Sensor
Sensor Alarm—Email Comment
PC Programming Manual References
13.5 PBX Configuration
—[5-5] Optional Device—External Sensor
Feature Guide References
2.18.3 External Sensor
Feature Guide 523
5.4.3 E-mail Notification of Sensor Alarm
To Next Page
Loading...
