• When
using Digital XDP connection, the following features cannot be used with either the master or slave
DPT:
a. OHCA: A call waiting tone will be heard even if the OHCA feature is set.
b. USB Module/Bluetooth Module: The DPTs will not work correctly if a USB Module or Bluetooth Module
is connected. Do not connect USB Modules or Bluetooth Modules to the DPTs.
Note
Even if the slave DPT is disconnected, the OHCA feature and USB Module still cannot be used with the
master DPT. To use them, the master DPT must be disconnected from the PBX, and then reconnected.
[DPT + DPT + SLT]
• When an SLT is connected to the slave DPT in parallel mode, the SLT works as the parallel extension of
the master DPT.
Installation Manual References
2.3.3 System Capacity
4.8.2 Parallel Connection of the Extensions
4.8.3 Digital EXtra Device Port (Digital XDP) Connection
PC Programming Manual References
9.22 PBX Configuration
—[1-1] Configuration—Slot—Port Property—Extension Type
→
XDP Mode
→ Parallel Telephone Ringing
10.6.1
PBX Configuration—[2-6-1] System—Numbering Plan—Main—Features—
Parallel Telephone (Ring)
Mode Set / Cancel
PT Programming Manual References
[600] EXtra Device Port (XDP) Mode
User Manual References
1.9.11 Setting the Parallelled Telephone to Ring
(Parallelled Telephone)
Feature Guide 183
2.11.10 Parallelled Telephone
To Next Page
Loading...
