Note
The following settings can also be specified in the DIL table:
• Tenant number: determines the time mode
(day/lunch/break/night) for the corresponding trunk.
• UM service group number: determines the service group to use when a call is handled by the Unified
Messaging system.
• VM trunk group number: used in Voice Mail DPT (Digital) Integration with a VPS.
Explanation:
If a trunk call is received from trunk 01;
In Day mode: CLI is enabled. Route to CLI destination.
In Lunch mode: CLI is disabled. Route to DIL destination, extension 100.
PC Programming Manual References
18.2 PBX Configuration
—[10-2] CO & Incoming Call—DIL Table & Port Settings—DIL
→
DIL Destination—Day, Lunch, Break, Night
→ Tenant Number
→ UM Service Group No.
→ VM Trunk Group No.
PT Programming Manual References
[421] BRI DIL/DDI/MSN Selection
[450] DIL 1:1 Destination
Feature Guide References
2.1.1.5 Calling Line Identification
(CLI) Distribution
3.2.1.39 Service Group
5.1.3 Tenant Service
5.1.4 Time Service
6.1 Capacity of System Resources
24 Feature Guide
2.1.1 Incoming Trunk Call Features
To Next Page
Loading...
