® 11.12.1 PBX Configuration—[3-12-1] Group—VM(DTMF) Group—System Settings—
Others—Intercept Routing to the VPS Sequence
Parameter
Transmitted Command
In AA Service Mode In VM Service Mode
Answer by Mailbox Switching to VM command +
Recording message command
(#6 + H [H = Mailbox No.])
Recording message command
(H [H = Mailbox No.])
AA Switching to AA command (#8) Switching to AA command (#8)
None (Default) (DTMF commands are not sent. Work with default of the VPS.)
[Example of a) & b)]
Trunk Call
Operator
Extn. 102
VM Port 1 VM Port 2
VM Port X
VM Port 3
VM (DTMF)
Group
VPS (In AA service mode)
FWD, Intercept
PBX
Transfer
Sent "#6" + "102".
Switching to VM command
mailbox number
c. Voice Mail (VM) Transfer Button
By
pressing the Voice Mail (VM) Transfer button during a call, an extension user can transfer a call to
a mailbox of the VPS so that the caller can leave a message in the mailbox of the desired extension.
When the extension user presses this button and enters the desired extension number, the PBX will
transfer the call to the VM group and dial the mailbox number of the desired extension with the required
command (after the VPS answers the call). Therefore the caller can leave a message without knowing
the mailbox number.
12.1.4 PBX Configuration—[4-1-4] Extension—Wired Extension—Flexible Button
→
Type
→ Extension Number (for Voice Mail Transfer)
12.2.3 PBX Configuration—[4-2-3] Extension
—Portable Station—Flexible Button
→
Type
→ Extension Number (for Voice Mail Transfer)
12.3 PBX Configuration
—[4-3] Extension—DSS Console
→
Type
→ Extension Number (for Voice Mail Transfer)
306 Feature Guide
2.28.2 Voice Mail DTMF Integration
To Next Page
Loading...
