Panasonic KX-NS500 - Page 478

3. Features Using Time Service
The following features can be set in each time mode
(day/lunch/break/night):
a. Destination of incoming trunk calls (DIL/DID/DDI/MSN) (® 2.1.1 Incoming Trunk Call Features)
b. Destination of the Intercept Routing (® 2.1.1.6 Intercept Routing)
c. Queuing Time Table for incoming call distribution groups (® 2.2.2.4 Queuing Feature)
d. Overflow destination for incoming call distribution groups (® 2.2.2.7 Overflow Feature)
e. Destination of incoming doorphone calls (® 2.18.1 Doorphone Call)
f. PBX operator (® 5.1.5 Operator Features)
g. COS for TRS/Barring and for Trunk Access
h. Outgoing Message (OGM) for Timed Reminder (® 2.24.4 Timed Reminder)
i. Intercept time for Intercept Routing—No Answer (® 2.1.1.6 Intercept Routing) and for DISA Intercept
Routing—No Answer (® 2.16.1 Direct Inward System Access (DISA))
j. Service group settings for voice mail (® 3.2.1.39 Service Group)
The following feature works only when the time mode is set to "break":
a. Using quick dialling to reroute a One-look network intercom call to a trunk during break mode
(® 2.6.5 Quick Dialling)
[Programming Examples of DID/DDI Table and DIL Table]
DID/DDI table can be programmed for each DID/DDI number, and a tenant (Time Table) number is
assigned to each DID/DDI number. DIL table can be programmed for each trunk, and a tenant (Time Table)
number is assigned to each trunk.
<DID/DDI Table>
Location DID/DDI No. Tenant
(Time Table)
No.
DID/DDI Destination
Day Lunch Break Night
001 123-4567 1 105 100 (UM) 105 100 (UM)
002 123-2468 1 102 100 (UM) 102 100 (UM)
: : : : : : :
<DIL Table>
Trunk No. Tenant (Time
Table) No.
DIL Destination
Day Lunch Break Night
01 1 101 100 (UM) 101 100 (UM)
02 2 102 100 (UM) 102 100 (UM)
: : : : : :
Explanation:
If a trunk call with a DID number (123-4567) is received at 20:00;
1. Tenant (Time Table) number 1 will be used.
2. The call is received during night mode in Time Table 1.
3. The call will be routed to extension 100
(UM Group).
4. Holiday Mode
The holiday mode activates automatically using the Automatic Switching mode. Up to 24 holidays (start
and end dates) can be stored, and one time mode can be selected for all holidays.
478 Feature Guide
5.1.4 Time Service