Panasonic KX-NS500 - Page 53

The FWD feature can be assigned on an incoming call distribution group basis.
• COS for Incoming Call Distribution Groups
Each incoming call distribution group is assigned a COS number. Group FWD to an outside party can be
enabled or disabled for each COS. The COS for incoming call distribution groups is also used for the
Internal Call Block feature; when an extension user calls an incoming call distribution group, the PBX
checks the COS of the calling extension against the COS of the incoming call distribution group
(® 2.1.2.2 Internal Call Block).
Installation Manual References
5.4.1 Easy Setup Wizard
PC Programming Manual References
11.5.1 PBX Configuration—[3-5-1] Group
—Incoming Call Distribution Group—Group Settings
→Main
→Overflow Queuing Busy
→Overflow No Answer
→Miscellaneous
11.5.1.1 PBX Configuration—[3-5-1] Group—Incoming Call Distribution Group—Group Settings—Member
List
11.5.3 PBX Configuration—[3-5-3] Group—Incoming Call Distribution Group—Miscellaneous—
Options—ICD Group Key Mode
PT Programming Manual References
[620] Incoming Call Distribution Group Member
[621] Incoming Call Distribution Group Delayed Ringing
[622] Incoming Call Distribution Group Floating Extension Number
[623] Incoming Call Distribution Group Name
[624] Incoming Call Distribution Group Distribution Method
[625] Destination for Overflow Time Expiration
[626] Overflow Time
[627] Destination When All Busy
[628] Queuing Call Capacity
[629] Queuing Hurry-up Level
[630] Queuing Time Table
[631] Sequences in Queuing Time Table
[632] Maximum Number of Agents
Feature Guide References
2.3.2 Call Forwarding
(FWD)
2.21.2 Flexible Buttons
5.5.8 Floating Extension
6.1 Capacity of System Resources
Feature Guide 53
2.2.2 Incoming Call Distribution Group Features