The FWD/DND status for trunk calls to that extension can be switched temporarily without clearing the
FWD
destination. During setting, the LED of the button shows the current trunk call FWD/DND status. The
forwarding type and destination for trunk calls can also be set.
• FWD/DND for intercom calls
The FWD/DND status for intercom calls to that extension can be switched temporarily without clearing the
FWD destination. During setting, the LED of the button shows the current intercom call FWD/DND status.
The forwarding type and destination for intercom calls can also be set.
• FWD—No Answer timer
The length of time until unanswered calls are forwarded can be modified. This setting is applied to both
intercom and trunk call forwarding.
• FWD for Virtual PS
If the extension is the first registered extension in an Incoming Call Distribution Group, the extension user
can set the FWD destination and forwarding status (on/off) for up to 4 virtual PSs preregistered to the group.
(® 5.2.4.6 Virtual PS)
These settings are only available when FWD/DND buttons are set through system programming to FWD/DND
Setting mode.
Conditions
• When FWD/DND buttons are set to FWD/DND Cycle Switch mode, pressing the FWD/DND button cycles
the FWD/DND setting.
In this mode, when intercom calls are set to be handled differently from trunk calls (forward destination,
DND on/off):
a. in idle mode, the light patterns of the FWD/DND—Both button (including FWD/DND button [fixed
button]) and the Group FWD—Both button will indicate the setting for either trunk calls or intercom
calls, but not both.
b. the FWD and DND icons on a PS display reflect the settings for trunk calls only.
c. pressing the FWD/DND—Both button (including FWD/DND button [fixed button]) or the Group
FWD—Both button will be ignored.
• When both the FWD and DND features are assigned simultaneously, pressing the button changes the
settings as follows:
• A FWD/DND button customised on a flexible button is always in FWD/DND Cycle Switch mode, and the
mode cannot be changed.
PC Programming Manual References
10.6.1 PBX Configuration—[2-6-1] System—Numbering Plan
—Main—Features
→
FWD/DND Set / Cancel: Call from CO & Extension
→ FWD/DND Set / Cancel: Call from CO
→ FWD/DND Set / Cancel: Call from Extension
→ Group FWD Set / Cancel: Call from CO & Extension
→ Group FWD Set / Cancel: Call from CO
→ Group FWD Set / Cancel: Call from Extension
10.9 PBX Configuration
—[2-9] System—System Options—Option 1
→
PT Fwd / DND—Fwd LED
→ PT Fwd / DND—DND LED
→ PT Fwd / DND—Fwd/DND key mode when Idle
12.1.1 PBX Configuration—[4-1-1] Extension
—Wired Extension—Extension Settings—FWD / DND
12.1.4 PBX Configuration—[4-1-4] Extension—Wired Extension—Flexible Button
→
Type
Feature Guide 89
2.3.4 FWD/DND Button, Group FWD Button
To Next Page
Loading...
