Panasonic KX-TDA200 - Page 174

Hold
Hold
(to be Retrieved from
Another Extension)
*1
Transfer to Trunk
Transfer to Exten-
sion
Mode 2
(Default)
Flashing the hooks-
witch
+
Hold Feature No.
+
Going on-hook
Flashing the hookswitch
+
Hold Feature No.
+
Going on-hook
Flashing the hooks-
witch
+
Trunk Access No.
Flashing the hooks-
witch
+
Extension No.
Mode 3
Flashing the hooks-
witch
+
Hold Feature No.
+
Going on-hook
Flashing the hookswitch
+
Hold Feature No.
+
Hold Feature No.
+
Going on-hook
Flashing the hooks-
witch
+
Hold Feature No.
+
Trunk Access No.
Flashing the hooks-
witch
+
Extension No.
Mode 4
Flashing the hooks-
witch
+
Hold Feature No.
+
Going on-hook
Flashing the hookswitch
+
Hold Feature No.
+
Hold Feature No.
+
Going on-hook
Flashing the hooks-
witch
+
Hold Feature No.
+
Trunk Access No.
Flashing the hooks-
witch
+
Hold Feature No.
+
Extension No.
*1
These operations must be performed when the held call is intended to be retrieved from another extension using the holding
extension number.
If the following occurs frequently with an SLT, choose "Mode 2", "Mode 3", or "Mode 4":
a. When an SLT user receives a call, reorder tone is heard or nobody answers the call.
b. When an SLT user goes off-hook, reorder tone is heard instead of a dial tone.
If a call is not terminated after going on-hook, the above cases occur. To avoid these problems,
choose "Mode 2", "Mode 3", or "Mode 4". Every call will be terminated unless the Hold feature number
is entered after flashing the hookswitch in
Mode 2, Mode 3, and Mode 4.
• Hold Alarm tone pattern has a default. (®
3.3.1 Tones/Ring Tones).
PC Programming Manual References
4.4 [2-3] Timers & Counters—Dial / IRNA / Recall / Tone
→
Recall—Hold Recall
→ Recall—Disconnect after Recall
4.8 [2-6-1] Numbering Plan—Main—Features
→
Call Hold / Call Hold Retrieve
→ Call Hold Retrieve : Specified with a Holding Extension Number
→ Hold Retrieve : Specified with a Held CO Line Number
4.17 [2-9] System Options
→Option 1—
PT Operation—Automatic Hold by ICM / CO / ICD Group key
→Option 1— PT Operation—Hold Key Mode
→Option 5— SLT—SLT Hold Mode
PT Programming Manual References
[200] Hold Recall Time
174 Feature Guide
1.13.1 Call Hold