Panasonic KX-TDA200 - Page 419

Feature
Default
Type 1
(with )
Type 2
(without )
KX-TDA30/
KX-TDA100/
KX-TDA200
KX-TDA600
Remote Wake-up Call 76 76 76
Timed Reminder set/cancel 760 760 760
Printing Message 761 761 761
Extension Dial Lock set/cancel 77 77 77
Time Service Switch 780 780 780
Remote Extension Dial Lock off 782 782 782
Remote Extension Dial Lock on 783 783 783
NDSS Monitor Release 784 784 784
Trunk Busy Out Clear 785 785 None
Extension Feature Clear 790 790 790
Extension Personal Identification Num-
ber (PIN) set/cancel
799 799 799
Dial Information (CTI) None None None
Other PBX Extension Number (TIE) 1–16 None None None
Quick Dialling
*1
None None None
*1
It is
possible to register Quick Dialling numbers that overlap with other registered numbers. This is used for Automatic Rerouting
of Calls via a Private IP Network to Public Trunks.
2. Flexible Numbering (available while a busy, DND, or ringback tone is heard)
Feature numbers which are available while a busy, DND, or ringback tone is heard can be customised for
easy use. The numbers should be one digit ("0" through "9", "
", or "#") and must not conflict. For default,
refer to the following table:
[Flexible Numbering Table (available while a busy, DND, or ringback tone is heard)]
Feature Default
Call Waiting/DND Override 1 or 2
*1
Executive Busy Override 3
Message Waiting set 4
Call Monitor 5
Automatic Callback Busy/CCBS 6
Alternate Calling—Ring/Voice
*1
To use Call Waiting/DND Override, both "1" and "2" are available by default.
Feature Guide 419
2.3.6 Flexible Numbering/Fixed Numbering