EasyManua.ls Logo

Panasonic KX-TDA600

Panasonic KX-TDA600
366 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
1.6 F
102 Feature Manual
1.6.2 Flash/Recall/Terminate
Description
A proprietary telephone (PT) user can use the FLASH/RECALL button (Flash/Recall mode or Terminate
mode) or Terminate button (Terminate mode) to disconnect the current call and originate another call without
hanging up.
Flash/Recall Mode: Disconnects the line and the extension user hears the dial tone from the line used last.
For example, if a CO line call is disconnected, the extension user will hear a new dial tone from the same
CO line.
Terminate Mode: Disconnects the line and the extension user hears a dial tone via the preferred CO line.
(→ 1.10.3 Line Preference—Outgoing)
Conditions
• FLASH/RECALL Button Mode
One of the following modes can be selected for each extension through system programming:
– Flash/Recall mode
– Terminate mode
–EFA mode. (→ 1.5.1 EFA (External Feature Access))
• Terminate Button
Any flexible button can be customized as the Terminate button.
• Disconnect Time (Only for Flash/Recall Mode)
The amount of time between successive accesses to the same CO line is programmable for each CO
line port.
• This feature generates a Station Message Detail Recording (SMDR) call record (→ 1.16.1 SMDR
(Station Message Detail Recording)), restarts the call timer, inserts a pause, and checks the Toll
Restriction (TRS) level (→ 1.17.6 TRS (Toll Restriction)) again.
• The Terminate feature will be performed when pressing the FLASH/RECALL button regardless of the
mode that the FLASH/RECALL button has been set to, in the following situations:
– When a call is made using ARS. (→ 1.1.3 ARS (Automatic Route Selection))
– When a CO line call is made with the INTERCOM button.
– When a CO line call is made with an Incoming Call Distribution (ICD) group button.
Programming References
PC Programming Manual
2.8.11 [1-1] Slot—Port Property - LCO Port—Disconnect Time
2.8.17 [1-1] Slot—Port Property - T1 Port (KX-TDA100/KX-TDA200/KX-TDA600 only)—Disconnect Time
2.11.1 [4-1-1] Wired Extension—Extension Settings—Option 7—Flash Mode during CO Conversation
2.11.5 [4-1-4] Wired Extension—Flexible Button—Type
2.11.10 [4-2-1] Portable Station—Extension Settings—Option 7—Flash Mode during CO Conversation
2.11.13 [4-2-3] Portable Station—Flexible Button—Type
2.11.17 [4-3] DSS Console—Type
PT Programming Manual
[418] LCOT Disconnect Time

Table of Contents

Other manuals for Panasonic KX-TDA600

Related product manuals