Panasonic KX-TDA600

1.9 I
156 Feature Manual
5. Intercept Routing
After a call has been directed to its DIL, DID, or CLI destination, the following Intercept Routing features,
if programmed, can redirect the call.
Programming References
PC Programming Manual
2.8.17 [1-1] Slot—Port Property - T1 Port (KX-TDA100/KX-TDA200/KX-TDA600 only)—Trunk Property
2.17.2 [10-2] DIL Table & Port Settings—DIL—Trunk Property
PT Programming Manual
None
1.9.11 Intercept Routing
Description
Redirects an incoming CO line call or intercom call to a preprogrammed destination when the original
destination does not, or can not, answer the call. There are four types of Intercept Routing, described below.
Type Description Details in
No Answer (IRNA) If a called party does not answer a call within a
preprogrammed time period (Intercept time), the call
is redirected to a preprogrammed destination.
• 1.9.11 Intercept
Routing
Busy If a called party is already handling another call, the
new call is redirected to a preprogrammed
destination.
DND If a called party is in Do Not Disturb (DND) mode, the
call is redirected to a preprogrammed destination.
No Destination If a destination is not assigned, the call is redirected
to an operator.
• 1.9.12 Intercept
Routing—No
Destination
Type Description
No Answer (IRNA) If a called party does not answer a call within a preprogrammed time period
(IRNA Timer), the call is redirected to a preprogrammed intercept destination.
The assigned intercept destination of the extension port.
→ 2.9.4 [2-3] Timers & Counters
→ Dial / IRNA / Recall / Tone—Intercept Routing No Answer (IRNA)—
Day, Lunch, Break, Night
→ DISA / Door / Reminder / U. Conf—DISA—Intercept Timer—Day,
Lunch, Break, Night
→ [203] Intercept Time