Panasonic KX-TDA600

1.4 D
Feature Manual 73
The tenant number programmed here is used only to determine the Time Table used by each CO line;
selecting tenant 3 means the CO line will use Time Table 3, for example. The VM trunk group number
set here is used to determine the Incoming Call Service and greeting message used by the Voice
Processing System (VPS) during the current time mode. (→ 1.19.4 Voice Mail DPT (Digital)
Integration).
Conditions
• To use this feature, DIL must be assigned as the distribution method for the desired CO line port.
Programming References
PC Programming Manual
2.17.2 [10-2] DIL Table & Port Settings—DIL
→ DIL Destination—Day, Lunch, Break, Night
→ Tenant Number
→ VM Trunk Group No.
PT Programming Manual
[450] DIL 1:1 Destination
Feature Manual References
1.3.12 CLI (Calling Line Identification) Distribution
1.9.10 INCOMING CALL FEATURES
1.17.5 Time Service
1.4.7 DISA (Direct Inward System Access)
Description
An outside caller can access specific PBX features as if the caller is an SLT extension user in the PBX, when
the incoming call destination is a DISA floating extension number assigned to each DISA message. The
caller can have direct access to features such as:
• Placing an intercom call to an extension, operator or any floating extensions (e.g., modem for
remote system administration, an external pager for TAFAS).
• Calling an outside party via the PBX.
• Operating some PBX remote features (e.g., FWD).