1.6 F
Feature Manual 111
[Flexible Numbering Table (available while a busy, DND, or ringback tone is heard)]
3. Fixed Numbering (available while dialing or talking)
Features which are available while dialing or talking have fixed numbers, as shown in the following table:
[Fixed Numbering Table (available while dialing or talking)]
Conditions
• The following are examples of feature number conflicts: 1 and 11, 0 and 00, 2 and 21, 10 and 101, 32
and 321, etc.
• Feature number + Additional number (Parameter)
Certain flexible feature numbers require additional digits to make the feature active. For example, to set
Call Waiting, the feature number for "Call Waiting" must be followed by "1" and to cancel it, the same
feature number should be followed by "0".
• Rotary single line telephone (SLT) users cannot dial feature numbers which include " " or "#".
• Portable station (PS) users cannot use the following features:
– Personal Speed Dialing
– OGM playback/record
– S-CO Line Access
– Parallel Telephone Mode set/cancel
– Walking Extension
– BGM set/cancel
– Timed Reminder
• A PS can only be assigned an extension number of 4 digits or less.
Programming References
PC Programming Manual
2.9.8 [2-6-1] Numbering Plan—Main
Feature Default
Call Waiting/DND Override 1 or 2*
Executive Busy Override 3
Message Waiting set 4
Call Monitor 5
Automatic Callback Busy 6
Alternate Calling—Ring/Voice
*: To use Call Waiting/DND Override, both "1" and "2" are available by default.
Feature Fixed Numbering
Pulse to Tone Conversion
Conference 3
Door Open 5
To Next Page
Loading...
