Panasonic KX-TDA600

1.9 I
166 Feature Manual
2. ISDN Supplementary Services for Public Network
3. Private Networking Connection (QSIG)
Private networking with QSIG is possible using an ISDN line. Each ISDN port must be programmed so
that each ISDN line has a "master" connection and a "slave" connection.
Conditions
• En bloc
The PBX sends all of dialed digits at once after the extension user completes dialing. The PBX
recognizes the end of dialing as follows:
– the # key is pressed (programmable).
→ 2.9.17 [2-9] System Options—Option 2—End of Dial Plan—[#] as End of Dial for en Bloc mode
(KX-TDA100/KX-TDA200/KX-TDA600 only)
– the dialed number is a preprogrammed telephone number.
→ 2.10.4 [3-1-4] Dialing Plan
– the inter-digit timer expires.
→ 2.9.4 [2-3] Timers & Counters—Dial / IRNA / Recall / Tone—Dial—Extension Inter-digit
• Extension Number
An extension number can be assigned to each ISDN port.
→ 2.11.1 [4-1-1] Wired Extension—Extension Settings—Main—Extension Number
• Network Type
Each ISDN port can be set to the requirements of each country/area.
• L1 Active Mode and L2 Data Link Mode
The active mode of Layer 1 (L1) and the data link mode of Layer 2 (L2) can be selected individually
(Permanent or Call by Call) for each ISDN port.
Service Description Details in
Direct Inward Dialing
(DID)
Directs a call with a DID number to the
preprogrammed destination.
• 1.4.5 DID (Direct
Inward Dialing)
Calling Line Identification
Presentation (CLIP)
Sends the caller's telephone number to the network
when making a call. The called party can see the
number on his or her telephone display before
answering the call.
• 1.3.13 CLIP
(Calling Line
Identification
Presentation)
Connected Line
Identification
Presentation (COLP)
Sends the telephone number of the answered party
to the network when answering a call. The caller can
see the number on his telephone display when the
line is connected.
Calling Line Identification
Restriction (CLIR)
Prevents the caller's CLI from being presented to the
called party.
Connected Line
Identification Restriction
(COLR)
Prevents COLP from being sent by the answered
party.
Caller ID The PBX receives Caller ID information, such as the
caller's name and telephone number, when a call is
sent from the network. A display proprietary
telephone (PT) user can see this information before
answering the call.
• 1.3.1 Caller ID