Panasonic KX-TDA600

1.1 A
20 Feature Manual
Modify Command: When a call is made using this carrier, the telephone number must be modified to
meet the criteria required by the carrier in order to connect the call. Program here the commands
needed to modify the user-dialed number as necessary.
[Command Explanation]
[Programming Example: Carrier Table]
*1
→ 2.15.6 [8-5] Carrier—Carrier—Carrier Name
→ [350] ARS Carrier Name
*2
→ 2.15.6 [8-5] Carrier—TRG 01–TRG 64 (KX-TDA50/KX-TDA100/KX-TDA200), or TRG 01–
TRG 96 (KX-TDA600)
→ [351] ARS Trunk Group for Carrier Access
*3
→ 2.15.6 [8-5] Carrier—Carrier—Carrier Access Code
→ [353] ARS Carrier Access Code
*4
→ 2.15.6 [8-5] Carrier—Carrier—Removed Number of Digits
→ [352] ARS Removed Number of Digits for Carrier Access
*5
→ 2.15.6 [8-5] Carrier—Carrier—Modify Command
Command
Description
Inserts the Carrier Access Code
Inserts the user-dialed number minus any removed digits
Analog Line: Inserts a pause
ISDN/T1 Line: Inserts a pause and changes dialing mode to tone (DTMF)
Inserts the Authorization Code for Tenant
Inserts the Authorization Code for Trunk Group
Inserts the Itemized Billing Code
You can enter any of these digits in a modify command
C
H
P
A
G
I
[0-9, , #]
In this example
Dialed number: 9-1-212-555-5555
Modification:
9 1 2125555555 0880 2125555555
Remove 1 digit Add the Carrier Access Code
CO Line Access no. is ignored
Carrier A
1, 2, 3
0880
1
CH
Carrier Name
*1
Trunk Group
*2
Carrier Access Code
*3
Removed No. of Digits
*4
Modify Command
*5
Carrier J
4
0700
3
CPH
Carrier 1 Carrier 2