1.13 P
250 Feature Manual
Conditions
• This feature can be enabled or disabled on each ISDN (QSIG) port of the PBX.
Programming References
PC Programming Manual
2.8.14 [1-1] Slot—Port Property - PRI Port (KX-TDA100/KX-TDA200/KX-TDA600 only)—Supplementary
Service—COLP, CLIR, COLR, CNIP, CONP, CNIR, CONR, CF (Rerouting), CT, CCBS, E911
2.8.32 [1-3] Option—New Card Installation—ISDN Standard Mode for PRI23 Card (KX-TDA100/KX-
TDA200/KX-TDA600 only)
PT Programming Manual
None
Operating Manual References
1.3.29 FWD (Call Forwarding)
[Example]
Extension 1000 of PBX-1 dials extension
number "2000", and the call is sent to
extension "2000" of PBX-2 through QSIG
network.
The call is forwarded to the forward
destination of CO line calls of extension
2000, which is extension "1001" of PBX-
1.
The call between PBX-1 and PBX-2 is
released, and the call is connected
directly to the forward destination of
extension 2000.
PBX-1
QSIG
PBX-2
Dials "2000".
PBX-1
QSIG
PBX-2
Extn. 1001 Extn. 2000
Extn. 1001 Extn. 2000
(Forward Destination
of CO Line Calls: 1001)
Call to 2000
1
Forwarded
to 1001
2
3
Extn. 1000
Extn. 1000
To Next Page
Loading...
