Panasonic KX-TDA600 - Page 255

1.13 P
Feature Manual 255
For receiving a call:
TIE line service programming
[TIE Line Routing and Modification Table]
[Explanation]
Calls to destinations with leading number "2" or "3" are automatically routed through the VoIP
ports, designated as trunk group 2.
• IP-GW (IP Gateway Circuit)
IP address assignment for the local PBX and other PBXs.
[Explanation]
Calls are routed to the IP address of each IP-GW card based on the leading number dialed.
Automatic Rerouting of VoIP Calls to Public CO Lines
When a VoIP call cannot be completed successfully, the PBX can automatically attempt to make the call
using a public CO line instead. This provides a backup method of making calls in cases when IP network
transmission cannot be completed successfully.
Location
No.
Leading
No.
Priority 1 Priority 2 . .
TRG
Dial Modification
TRG
Dial Modification . .
Removed
No. of
Digits
Added No.
Removed
No. of
Digits
Added No. . .
01 2
2 (VoIP
port)
0. .
02 3 2 0 . .
:::: : :: ::
[Programming Example]
Destination
Leading No. IP Address
2 200.45.11.35
3 199.176.64.1
::