Panasonic KX-TDA600

1.5 E
98 Feature Manual
[Available Destinations]
When the call is answered, if distinctive dial tones are enabled, dial tone 3 is heard, which continues until
the user goes on-hook. If the sensor call is not answered within a specified time, the call will be canceled.
It is possible to set a different ring tone pattern for calls received from each external sensor, to distinguish
between them.
Conditions
• Hardware Requirement:
KX-TDA50: An external sensor and DPH card
KX-TDA100/KX-TDA200/KX-TDA600: An external sensor, OPB card and EIO card
• Some devices may be unable to communicate correctly with the PBX. Confirm compatibility with the
manufacturer of a device before installing it.
• After a sensor has been activated, the PBX will ignore any further alerts from the same sensor for the
duration specified by a timer. This timer can be set separately for each sensor.
• As long as the previous sensor call is still being performed, any further alerts from the same sensor are
ignored.
• The assigned sensor name and/or number are shown on the display of PTs and PSs when a sensor
call is received.
• If the destination of a sensor call has set FWD, the sensor call will be redirected to the FWD destination.
However, if the FWD destination is not supported as the destination of a sensor call (e.g., an outside
party), the call will be received at the original destination. (→ 1.6.6 FWD (Call Forwarding))
• The following features cannot be used when a sensor call is received:
– Alternate Receiving—Voice (→ 1.9.13 Intercom Call)
– Hands-free Answerback (→ 1.8.1 Hands-free Answerback)
– Consultation Hold/Call Hold (→ 1.3.2 Call Hold)
Destination Availability
Wired Extension (PT/SLT/T1-OPX)
PS
ICD Group
PS Ring Group
Floating Extension no. for SVM
VM Group (DTMF/DPT)
External Pager (TAFAS)
DISA
Analog/ISDN Remote Maintenance
Idle Line Access no. + Phone no.
Trunk Group Access no. + Trunk Group no. + Phone no.
Extension of Another PBX (via TIE Line, Access with PBX Code)
Extension of Another PBX (via TIE Line, Access without PBX Code)