Panasonic KX-UTG200

Value Range Max. 1024 characters
Note
• The format must be RFC 1738 compliant, as follows:
"<scheme>://<user>:<password>@<host>:<port>/<url-path>".
– "<user>" must be less than 127 characters.
– "<password>" must be less than 127 characters.
– "<user>:<password>@" may be empty.
– ":<port>" can be omitted if you do not need to specify the
port number.
• If "{mac}" is included in this URL, it will be replaced with the
unit’s MAC address in lower-case.
• If "{MAC}" is included in this URL, it will be replaced with the
unit’s MAC address in upper-case.
• If "{MODEL}" is included in this URL, it will be replaced with the
unit’s model name.
• If "{fwver}" is included in this URL, it will be replaced with
"FIRM_VERSION" depending on the system. Note that this rule
differs from other parameters such as "SIP_USER_AGENT".
Default Value Empty string
KEM_UPGRADE_AUTO
Value Format Boolean
Description Specifies whether to display a confirmation message asking the user
to perform a KEM update (manual) or perform the KEM update without
asking the user (automatic) when the unit detects a newer version of
KEM.
Value Range
• Y (Enable automatic KEM update)
• N (Disable automatic KEM update)
Default Value Y
5.3.5 Firmware Update Settings
FIRM_UPGRADE_ENABLE
Value Format Boolean
Description Specifies whether to perform firmware updates when the unit detects a
newer version of firmware.
Note
• Changing this setting may require restarting the unit.
• Local firmware updates from the Web user interface (® see
4.8.4 Local Firmware Update) can be performed regardless
of this setting.
Document Version 2014-05 Administrator Guide 227
5.3.5 Firmware Update Settings