103
VQT1Z56
Advanced (Playback)
You can add text (comments) to pictures. After text has been registered, it can be included
in prints using [TEXT STAMP] (P104). (Only alphabetic characters and symbols can be
entered.)
Names set in [BABY1]/[BABY2] and [PET] in scene mode or [LOCATION] in travel date
are also recorded as the titles.
Select [TITLE EDIT] on the [PLAYBACK] mode menu. (P26)
Press 3/4 to select [SINGLE] or [MULTI] and then
press [MENU/SET].
Press 3/4/2/1 to select text and then press
[MENU/SET] to register.
• Press [DISPLAY] to switch text between [A] (capitals), [a] (small
case) and [&/1] (special characters and numbers).
• The entry position cursor can be moved left and right with the
zoom lever.
• To enter a blank, move the cursor to [SPACE] or to delete an entered character, move
the cursor to [DELETE], and press [MENU/SET].
• To stop editing at any time during text entry, press [‚].
• A maximum of 30 characters can be entered.(Maximum of 9 characters when setting
names in [FACE RECOG.])
Press 3/4/2/1 to move the cursor to [EXIT] and then press
[MENU/SET] to end text input.
Press [‚] to return to the menu screen.
¢
¢The menu screen is automatically restored when [MULTI] is selected.
• Press [MENU/SET] to close the menu.
[TITLE EDIT]
Select the picture, and then press
[MENU/SET] to set.
• [’] is displayed for pictures with titles
already registered.
[MULTI] setting
Press [DISPLAY] to set (repeat), and
then press [MENU/SET] to set.
[SINGLE] [MULTI]
Press 2/1 to
select the picture.
Press 3/4/2/1 to
select the pictures.
•
The setting is cancelled when [DISPLAY] is pressed again.
DMC-FT1&TS1EB-VQT1Z56_eng.book 103 ページ ２００９年２月２日 月曜日 午前９時４７分
To Next Page
Loading...
