125
VQT1Z56
Connecting to other equipment
Note
•
Do not use any other USB connection cables except the supplied one.
Use of cables other than the supplied USB connection cable may cause malfunction.
• Turn the camera off before connecting or disconnecting the AC adaptor (DMW-AC5E;
optional).
• Before inserting or removing a card, turn the camera off, and disconnect the USB connection
cable.
• You cannot switch between the built-in memory and the card while the camera is connected to
the printer. Disconnect the USB connection cable, insert (or remove) the card and then connect
the USB connection cable to the printer again.
• The pictures recorded in clipboard mode, copy them onto a card (P96), and then print them out.
• HDMI connection is disabled and connection with the USB connection cable will take priority
when you connect the USB connection cable while the HDMI mini cable is connected (P115).
Selecting a single picture and printing it
Press 2/1 to select the picture and then press
[MENU/SET].
• The message disappears in about 2 seconds.
Press 3 to select [PRINT START] and then press
[MENU/SET].
• Refer to P126 for the items which can be set before starting to
print the pictures.
• Press [MENU/SET] to cancel printing halfway.
• Disconnect the USB connection cable after printing.
Selecting multiple pictures and printing them
Press 3.
Press 3/4 to select an item and then press
[MENU/SET].
• If the print check screen has appeared, select [YES], and print
the pictures.
PictBridge
MULTI PRINT
100-0001
100-0001
PLEASE SELECT
THE PICTURE TO PRINT
SELECT
PRINT
12
OFF
1
CANCEL
SELECT
SET
PRINT START
PRINT WITH DATE
NUM. OF PRINTS
PAPER SIZE
PAGE LAYOUT
SINGLE SELECT
MULTI SELECT
SELECT ALL
PRINT SET (DPOF)
FAVORITE
PictBridge
CANCEL
SELECT
SET
DMC-FT1&TS1EB-VQT1Z56_eng.book 125 ページ ２００９年２月２日 月曜日 午前９時４７分
To Next Page
Loading...
Need help?
General
Weight and Dimensions
