Panasonic LUMIX DMC-FT1 User Manual

VQT1Z56
138
Others
• Was this picture taken with the flash at the close range when the zoom is near [W] (1k)?
> Zoom in a little, and then take the pictures. (P43)
• Is this a picture taken in [PIN HOLE] in scene mode?
> Check that the exposure is correctly compensated. (P56)
• Setting the [MIN. SHTR SPEED] to faster speed might make the picture darker.
> Set the [MIN. SHTR SPEED] (P92) to slower speed.
> Set auto bracket (P57), [HI-SPEED BURST] (P65), [FLASH BURST] (P65) in Scene mode
or [BURST] (P90) of the [REC] mode menu to [OFF].
• The focus range varies depending on the recording mode.
> Set to the proper mode for the distance to the subject.
• The subject is beyond the focus range of the camera. (P41)
• There is camera shake (jitter) or the subject is moving slightly. (P42)
• Turn the power on again. If the operations are still not working normally, remove the power and
consult the dealer or your nearest service centre.
> The shutter speed becomes slower when pictures are taken in dark places so hold the
camera firmly with both hands to take the pictures. (P35)
> When taking pictures at a slow shutter speed, use the self-timer. (P55)
• Is the number of recordable pictures 2 or less?
• Is the ISO sensitivity high or the shutter speed slow?
(ISO sensitivity is set to [AUTO] when the camera is shipped. Therefore, when taking pictures
indoors etc. noise will appear.)
> Decrease the ISO sensitivity. (P85)
> Set [COLOR MODE] to [NATURAL]. (P91)
> Take pictures in bright places.
• Has [HIGH SENS.] or [HI-SPEED BURST] in the scene mode been set? If so, the resolution of
the recorded picture decreases slightly because of high sensitivity processing, but this is not a
malfunction.
The area around where the pictures were taken becomes dark.
The recorded picture is too bright or dark.
2 or 3 pictures are taken at one time.
The subject is not focused properly.
The auto-focus and other operations are not working normally.
The recorded picture is blurred.
The optical image stabilizer is not effective.
Taking pictures using auto bracket is not possible.
The recorded picture looks rough.
Noise appears on the picture.
DMC-FT1&TS1EB-VQT1Z56_eng.book 138 ページ ２００９年２月２日 月曜日 午前９時４７分

Panasonic LUMIX DMC-FT1 Specifications

General

Megapixel	12.1 MP
Camera type	Compact camera
Sensor type	CCD
Supported aspect ratios	3:2, 4:3, 16:9
Digital zoom	36 x
Optical zoom	4.6 x
Fixed focal length	35 mm
Focal length range	4.9 - 22.8 mm
Number of aspheric elements	5
Interface	mini HDMI
Digital SLR	No
Built-in flash	Yes
Dimensions (WxDxH)	98.3 x 23 x 61.3 mm
Camera shutter speed	8 - 1/1300 s
Effective sensor resolution	12.7 pixels
Focal length (35mm film equivalent)	28 - 128 mm
Normal focusing range	0.3 - ∞ m
Macro focusing range (tele)	0.3 m
Macro focusing range (wide)	0.05 m
Internal memory	40 MB
Compatible memory cards	mmc, sd
Maximum video resolution	320 x 240 pixels
Display diagonal	2.7 \
USB version	2.0
Product color	Gold
Flash modes	auto, fill-in, manual, Red-eye reduction
Light exposure modes	auto, manual
Camera shutter type	electronic, mechanical

Weight and Dimensions

Depth	23 mm
Width	98.3 mm
Height	61.3 mm
Weight	183.8 g