Connecting with other devices
Printing
VQT5B76- 197 -
Preparation:
• When printing pictures from the
built-in memory, remove any memory
cards.
• Adjust the print quality or other
settings on your printer, as needed.
• Turn on the camera and printer.
Connect camera to printer
• Do not use any other USB connection cables except the supplied one or a
genuine Panasonic USB connection cable (DMW-USBC1: optional).
Using cables other than the above may cause a malfunction.
Press on the camera to select [PictBridge(PTP)], and
press [MENU/SET]
●
Disconnect USB connection cable (supplied) after printing.
●
Use a battery with sufficient battery power or the AC adaptor (optional). When the
battery begins to run out during communication, a warning beep sounds. Cancel
printing and disconnect USB connection cable (supplied).
●
Before connecting or disconnecting the AC adaptor (optional), turn the camera off.
●
Before inserting or removing a card, turn the camera off and disconnect the USB
connection cable.
●
Still pictures recorded in a RAW file cannot be printed. (The still pictures recorded in
JPEG file format at the same time as the RAW file can be printed.)
●
Motion pictures cannot be printed.
Check the plug direction and insert it straight in.
(If the cable is inserted in the wrong direction, the plug
could become deformed and cause faulty operation)
• Do not disconnect the USB
connection cable (supplied) when
the cable disconnection icon [
] is
displayed (may not be displayed with
some printers).
USB connection cable
(supplied)
You can connect directly to a PictBridge-compatible printer for printing.
• Some printers can print directly from the camera’s memory card.
For details, see the manual for your printer.
To Next Page
Loading...
