Preparations
About the Built-in Memory/the Card
VQT5B76
- 24 -
●
While the camera is accessing the card or built-in memory (for an operation such as
picture writing, reading, deletion, or formatting), do not turn off the camera or remove
the battery, card, AC adaptor (optional) or DC coupler (optional). Do not subject the
camera to vibrations, impact, or static electricity. The card or the data on the card may
be damaged, and this unit may no longer operate normally. If operation fails due to
vibration, impact or static electricity, perform the operation again.
●
Please reformat the card with this camera if it has already been
formatted with a computer or another device. (→73)
●
If the write-protect switch is set to “LOCK”, the card cannot be used to
record or delete pictures, and it cannot be formatted.
●
It is recommended that you copy important pictures to your computer
(as electromagnetic waves, static electricity, or faults may cause data
to be damaged).
●
Make sure that there are no foreign materials such as dust or water
on the terminals on the back of the card. Do not touch the terminals
with your hand. Doing so may cause this unit to malfunction.
Switch
Recording capacity guidelines (pictures/recording time)
■
About the display of the number of recordable pictures and available
recording time
• Switching between the display of number of recordable
pictures and available recording time can be performed in
the [Remaining Disp.] (→66) in the [Setup] menu.
• The number of recordable pictures and the available
recording time are an approximation. (These vary depending
on the recording conditions and the type of card.)
Number of
recordable
pictures
Available
recording time
■
Recording picture capacity (still pictures)
[Picture Size] Built-in memory 2 GB 32 GB 64 GB
16M 33 300 4910 9880
5M 74 650 10620 21490
0.3M 1140 10050 162960 247150
• When the number of recordable pictures exceeds 99,999, “+99999” is displayed.
To Next Page
Loading...
