Application (Record)
Taking pictures with the built-in flash
VQT5B76- 78 -
You can use the built-in flash to take pictures in dark locations or light up a subject to
adjust the contrast of an entire picture when the background is bright.
Press [ ] to open the flash
■
Closing the built-in flash
When you do not want to use the flash or after using the flash,
press down to retract the flash until it clicks.
• Be sure to close the flash when not in use.
●
Be careful not to catch a finger or any other part of your body or any object when you
close the flash.
●
Be sure to keep the flash clean, clear of dust and avoid exposure to anything sticky.
This may cause the flash to stick and not open.
●
Do not bring the flash too close to objects or close the flash while it is activated. The
objects may be discolored by its heat or lighting.
●
Do not close the flash immediately after the preliminary flash is operated prior to
taking pictures for Auto/Red-Eye Reduction and other flash settings. If you close the
flash immediately, it will cause a malfunction.
●
When the flash is being charged, the flash icon flashes red, and you cannot take a
picture even when you fully press the shutter button.
●
The flash effect may not be sufficient in the following cases:
• The flash effect may not be sufficient when shutter speed is fast.
• When [Burst] is set to [ ]
●
Flash charging may take time if battery is low or if using flash repeatedly.
●
When an External Flash is attached, it will have priority over the built-in flash. (→205)
To Next Page
Loading...
