66
Connecting to PC
[Preparation]
Only if using Windows 98 or 98SE, start
the supplied CD from PC and install the
USB driver.
1
Connect the camera to PC via the
supplied USB cable.
2
After inserting the memory card into
the camera, turn the power switch
to [ON] and set the mode dial to
playback [ ].
[Windows]
The drive is shown on the [My
computer] folder.
• If it is the first time connecting the
camera to PC, the required driver is
installed automatically in order to let
the camera be recognized by the
Windows Plug and Play, then it is
shown on the [My computer] folder.
[Macintosh]
The drive is shown on the screen.
• For further information, read the supplied operating instructions for the USB
connection kit.
• When connecting to PC, it is recommended that you use the AC adaptor
(optional, DMW-AC1) as the power source.
KC5.book66ページ２００２年４月１２日 金曜日 午前１０時８分
To Next Page
Loading...
Need help?
General
